G3 Boat Rolls to Port

General boating discussion
Wishbone5902
Posts: 1
Joined: Tue Mar 08, 2022 1:58 pm
2

G3 Boat Rolls to Port

#1

Post by Wishbone5902 »

I have a 2019 G3 18 ft DLX Bay Series with a 90 VMax Yamaha. I recently had the prop repaired for a slightly bent blade and afterwards the boat now rolls significantly to the left (port) side and does not plain off without applying significant motor trim. I noticed that the right (starboard) side fixed trim tab has been ground down while the left (port) has not been touched. Is this the reason for the roll problem? If so, do I need to replace the starboard trim tab or grind off the port tab to match the other?

Note/question; the boat does have float pods on the rear (stern) and I've heard the trim tabs are not needed?
 
User avatar
welder
Site Admin
Posts: 4667
Joined: Thu Jan 03, 2008 11:51 pm
16
Location: Whitesboro, Texas
Contact:

Re: G3 Boat Rolls to Port

#2

Post by welder »

Did this do this before the prop repair?
Lester,
PacificV2325, Honda BF225
2386
Post Reply Previous topicNext topic