Hello.
I applied Nyalic 3 days ago after spending days getting the hull on a 22 foot bouton all cleaned up to 320 grit. I had no idea I had this much elbow grease.
Unfortunately while in the research phase I was given some bad advice on which kind of foam roller to use and while I was applying it started to break down...... so I needed to immediately back off....
There were runs and some not so great waves in the Nyalic I was unable to smooth out and running a lint-free paper towel soaked in Nyalic unfortunately did not do the trick..
So now I am left with a very undesirable finish.
I am hoping I can sand and resurface the uneven spots in the Nyalic and run another coat over the top with a better roller I just recently found.
Do anyone advise against this?
Any help would be incredibly appreciated.
Applying Nyalic
General boating discussion
Jump to
- Boating Forum
- ↳ Alloy Boat Forum
- ↳ Your Alloy Boat
- ↳ Fishing your Alloy Boat
- ↳ Alloy Shop Talk
- ↳ Alloy Pictures
- ↳ Hauling Your Alloy Rig
- ↳ Take your kid/a service member fishing
- Helpful Info
- ↳ Helpful Info
- Can't Get On The Water
- ↳ Sittin' on the Dock
- ↳ Video links
- ↳ Meet & Greet
- Motors and Electronics
- ↳ Electronics
- ↳ Motors: OB's, IB's, Diesel and Gas
- ↳ MMSI List
- Welcome To AluminumAlloyBoats.com
- ↳ Welcome New Members
- ↳ Forum Rules
- Boat Building-Repairs and Upgrades
- ↳ Share your Projects and Creations
- ↳ Custom Skiff Build
- Aluminum Boat Manufacturers and Dealers
- ↳ Manufacturers
- ↳ Post Manufacturer Links here
- ↳ Sponsors
- The Tackle Room
- ↳ Rods, Reels, Line and Terminal Tackle
- Guides and Outfitters
- ↳ Guides and Outfitters in Action
- ↳ Jettywolf Charters
- For Sale
- ↳ Aluminum Boats For Sale
- ↳ Personal items For Sale or Trade
- Links to Sites we Like
- ↳ Boating and Fishing web sites
- Recipes
- ↳ Recipes