Applying Nyalic

General boating discussion
joshboats
Posts: 3
Joined: Thu Feb 25, 2021 9:48 pm
3

Applying Nyalic

#1

Post by joshboats »

Hello.

I applied Nyalic 3 days ago after spending days getting the hull on a 22 foot bouton all cleaned up to 320 grit. I had no idea I had this much elbow grease.

Unfortunately while in the research phase I was given some bad advice on which kind of foam roller to use and while I was applying it started to break down...... so I needed to immediately back off....

There were runs and some not so great waves in the Nyalic I was unable to smooth out and running a lint-free paper towel soaked in Nyalic unfortunately did not do the trick..

So now I am left with a very undesirable finish.

I am hoping I can sand and resurface the uneven spots in the Nyalic and run another coat over the top with a better roller I just recently found.

Do anyone advise against this?

Any help would be incredibly appreciated. :titanic: