Corrosion resistance products

Get help and share Ideas
Boxboy
Posts: 13
Joined: Wed Mar 27, 2019 8:16 pm
5

Corrosion resistance products

#1

Post by Boxboy »

Hi all, been working ( well researching) on what path to take in the boat remodel I am working on ( well I have a guy doing the work) . I have the fuel tank out, acid washed the inside hull, burred out the pitting and tig filled them up. And now need to decided on if I should spray the inside hull / bilge with a coating, before we install the 2 new fuel tanks.
Anyways doing all this research and came across this comparison /study.

https://corrosion-doctors.org/Inhibitor ... -Spray.htm

It seems to mention all the ones that keep popping up here like boeshield t9, atf50 etc.


Other improvements I am doing to make the hull less prone to corrosion is adding bilge fans and ventilation as the prior design had zero air circulation. Also considering putting in a small anode (aluminum) in the inside of the wet area of the bilge to a frame member.
Chaps
Donator '09
Posts: 2246
Joined: Sun Jan 13, 2008 12:19 am
16
Location: Seattle, WA

Re: Corrosion resistance products

#2

Post by Chaps »

"Also considering putting in a small anode (aluminum) in the inside of the wet area of the bilge to a frame member."

Good idea
1987 24' LaConner pilothouse workboat, 225 Suzuki
Image
please view and like: https://www.facebook.com/bottompainting/
Boxboy
Posts: 13
Joined: Wed Mar 27, 2019 8:16 pm
5

Re: Corrosion resistance products

#3

Post by Boxboy »

Thanks Chaps.

On the subject of anodes can you have too much aluminium anode on your hull or is it more robust than being over zinced?

According to boatzinc webpage xcal you need 3 times as much zinc anode in weight than you do for aluminum.
https://www.boatzincs.com/anode_weight_calculation.html

I have these canard performance fins with long zinc anodes 3"x40" which I am replacing with aluminum but didn't want to get over aluminum anodes...


As for spraying the hulls interior seems a non water displacing film is best if you have a dry hull to spray like I do. But my best defense and prevention is forced air flow through the bulges and keep it dry...

Happy father's day to all.
Attachments
Screenshot_20200620-223813_Gallery.jpg
Screenshot_20200620-223813_Gallery.jpg (18.47 KiB) Viewed 7437 times
Chaps
Donator '09
Posts: 2246
Joined: Sun Jan 13, 2008 12:19 am
16
Location: Seattle, WA

Re: Corrosion resistance products

#4

Post by Chaps »

You can't overprotect with aluminum anodes, put on as many as you want with no harm done but putting on more than you need is pointless. Overprotection occurs when there is a major difference in galvanic potential between the anode and what you want to protect keeping in mind that the conductivity of the water is the wildcard. An example of that would be installing magnesium anodes on an aluminum boat that will be used in salt or brackish water, the anodes would go into hyperdrive waste mode (overprotecting). In clean fresh (low conductivity) water the magnesium anodes would be fine.
1987 24' LaConner pilothouse workboat, 225 Suzuki
Image
please view and like: https://www.facebook.com/bottompainting/
Post Reply Previous topicNext topic